16m2 Top Cover Solution Dyed Polyester

This 16m2 Top Cover is made of woven solution dyed polyester with a PVC coating on the inside. The solution dyed material ensures minimal to no discoloration. The PVC coating makes the top cover non-breathable, but to solve this issue, there are 2 ventilation screens on both sides.

The 16m2 top cover can be used with a standing mast and extends over the boom. The tent features cut-outs for the shrouds, mast, and mooring lines. At the rear, there is an opening for an outboard motor covered with a flap. This flap can be removed if you have a motor at the back of the boat, or you can leave the top cover closed. There are two zippers on the port side of the mast and at the back by the cockpit. Opening both zippers allows you to fold the section between them over the boom, creating a large open area. The tent is weighted with removable sandbags, allowing for weight adjustment and easy folding. Additionally, there are 3 loops on each side for securing the top cover under the boat with lines to prevent it from blowing inwards, even in windy conditions.

• Woven polyester with PVC coating on the inside
• Solution dyed (minimal to no discoloration)
• Non-breathable material, with ventilation screens
• Reinforced in crucial areas
• Covers the whole boat
• For standing mast
• Over the boom for good drainage
• Water repellent
• Cut-out with flap for outboard motor
• 2 zippers on the side for entry
• Zipper by mast closes from bottom to top
• Zipper at the back closes from top to bottom
• Cut-outs for shrouds
• Cut-outs for mooring lines at the back
• Sealable around mast
• Loops underneath for additional securing under the boat
• Includes 12 removable sandbags
• Weight excluding sandbags: approximately 8.2kg (heavier due to PVC coating)
• Weight including sandbags: approximately 14.2kg